1997 G16e

[bschremp]

I had a member drop off his Yamaha cart yesterday in a no run condition. I'm not familiar with them as I've only worked on EZ-GOs. I poked around it a little today found a blown 10 amp fuse. Replaced the fuse and got the solenoid to pop but still no forward or reverse. Thought I better get some reference material before I went any farther. Any help would be appreciated.

Brian
Lafayette Elks Country Club

[Michael Eddie]

Hi bschremp, run a 6 gage wire across the large terminals on the solenoid. If it runs then your solenoid is toast.

[bschremp]

I jumped the solenoid posts but still have a no run situation.

[Michael Eddie]

Check the voltage on all batteries, and all the connections on the batteries and the solenoid. If this doesnt do it, you may be looking at a controller issue.

[bschremp]

Turned out to be a bad controller. Bought a rebuilt from Cart Parts Inc. at about half the cost of a new one and it's back up and running. The member is happy and I'm a fifth of Gentelman Jack richer! Thanks for all your help, greatly appreciated.

[Michael Eddie]

Glad we helped you get it figured out, also thanks for the followup! Happy carting

[dicksta]

g16e

I need a g16e wiring diagram

[Michael Eddie]

I need a g16e wiring diagram

There is one in the diagrams section, you are welcome to it.

[robandoli6]

I'm working on a 98 g16e and i replaced the relay solenoid and i worked in forward but when i switched it to reverse i smoked the batteries. I beieve its missed wired according to the wiring diagram but there is 2 wires i'm not sure where they go. the wiring diagram is a little vague. I would appreciate it greatly if someone could take a picture of there wiring so I can tell where mine go. Thank you!!