I have a G16E that is 36 volt. I just put in new batteries and fully charged them. Every time I press on the accellerator all I get is a click noise. What is the problem?
cart doesnt wanna run
Collapse
Forum Announcement
Collapse
No announcement yet.
X
-
lots of people think because the solenoid clicks that its good.........not always............. thrash is right jack the rear end up and jump the large post on solenoid use a peice of 6 gage cable.......while your at it if you put new batteries in make sure you wired it back up right............can,t tell you how many times i have seen that happen, also check all cables to make sure you didn,t forget to tighten one up.....................................Tom
if i didn,t like them so much i wouldn,t touch them...........
Comment
-
BIG BIG SPARKS, I guess I need to dig deeper, new battery's I just installed, but I bought the cart and the guy I purchaced it from said it did run but batteries went dead and the charger took a dump, I repainted the cart and put new trim on it. now I want it to run. Push on the pedal a click but nothing happens.
Comment
-
Posted earlier by lestersboyBIG BIG SPARKS, I guess I need to dig deeper, new battery's I just installed, but I bought the cart and the guy I purchaced it from said it did run but batteries went dead and the charger took a dump, I repainted the cart and put new trim on it. now I want it to run. Push on the pedal a click but nothing happens.Regards
Comment
-
Yes it clicks when I press the pedal down but the wheels won't turn forward or reverse. When I tried to jump the big terminals with a large screw driver it was ready to weld so I could not test the accelerator pedal. I went to the wiring diagram but I am unable to print it due to a printer problem. I can paint and turn wrenches but I am an admitted idiot with electrical if it is at all complicated. I don't want to send it to a shop and get milked.
Comment
-
Posted earlier by lestersboyYes it clicks when I press the pedal down but the wheels won't turn forward or reverse. When I tried to jump the big terminals with a large screw driver it was ready to weld so I could not test the accelerator pedal. I went to the wiring diagram but I am unable to print it due to a printer problem. I can paint and turn wrenches but I am an admitted idiot with electrical if it is at all complicated. I don't want to send it to a shop and get milked.Updated by lestersboy; August 20, 2009, 08:01 PM.
Comment
Recent posts in current forum
Collapse
Unconfigured Ad Widget
Collapse
Unconfigured Ad Widget
Collapse
Comment