Reverse buzzer on 2009 EZGO RXV

[rlewis123]

Can I eliminate the reverse buzzer on my RXV? It is driving me crazy. I can't even figure out where it is located as there is a safety shield near the controller.

[wthompson]

The reverse buzzer is under the seat on the passenger side under the splash guard for the electronics. Remove the three screws and/or push tabs. Should be a small round plastic piece with two wires black and red. The electronics on the rxv are very picky so i don't believe you can just unplug it. Take a piece of electrical tape or an ear plug and cover the buzzer hole. Should quiet it down enough.

[rlewis123]

OK - this is what I was afraid of - If I just cut the wires there would be consequences. I have my little ear plug taped in place and it is working nicely - Thanks!

[rlewis123]

I guess the followup question on this is if the RXV is looking for a specific load on the reverse buzzer circuit or if an LED reverse light can be added without upsetting the system?

[thrushl]

The reverse buzzer is under the seat on the passenger side under the splash guard for the electronics. Remove the three screws and/or push tabs. Should be a small round plastic piece with two wires black and red. The electronics on the rxv are very picky so i don't believe you can just unplug it. Take a piece of electrical tape or an ear plug and cover the buzzer hole. Should quiet it down enough.

Electric tape around the buzzer does the trick nicely as suggested.