wont charge

[wanglerbob]

--------------------------------------------------------------------------------

I have an old jacobsen 1110 hualer- with a eh350 robin engine

The starter generator has been replaced and it wont charge, So I put a new vr in the old one said ezgo on it-was the jacobsen built by ezgo?

The machine starts fine. but no charge. I have a2 to f1 - a1 to ground - f2 to positive on relay is this right?

The starter generator has two small wires green and red. If I touch the grean to battery positive the generator will put out 17 volts. Where does the red go to ground

Help please
Thanks Bob

[dougmcp]

In the 1989 wiring diagram, green goes to D+ on the voltage regulator and red goes to A on the F/R switch.
What year is the cart?

[wanglerbob]

SERAIL NUMBER 9221
I belive its a 1991

my vr has a grean a red and a black wire
I have green from generator going to the green on the vr-is this correct?
Red on the vr going to positive side on the solinoid
and black on the vr going to ground

What is the f/r switch

Thanks for your help - I came on this project midpoiont so I was not shure how it was wired originally

[wanglerbob]

any one have a 1110 hauler that could let me know where the wires go

Thanks bob

[dougmcp]

This is not the 1100 hauler but the equivalent Ezgo X series trucks, it's the best info I could come up with.
Hope it helps....

[wanglerbob]

Thanks for your help.

[dougmcp]

Did the diagram help the wire locations?
Did you get it working?

[wanglerbob]

Yes
The machine now charges

Thanks for your help

[dougmcp]