reverse but no forward

[easyrider1078]

Hi ,I have a 1994 Club car with the ignition switch in the on position and the F/R switch in the forward position when I press down on the accelerator the solenoid clicks but the cart will not go forward...when I change the F/R selector to Reverse the cart goes full speed in reverse without doing anything...Help please!!

[wthompson]

does your cart have resistors or solid state controller?

[easyrider1078]

Solid State controller.

[easyrider1078]

when I place the F/R lever in F and push up on the first switch lever(the one that's on the left of photo) the cart moves forward... pulling my hair out now!..:-(

[wthompson]

try posting the picture again, it's not showing up.

[easyrider1078]

ok hope it showed up this time...

[easyrider1078]

when I place the F/R lever in F and push up on the first switch lever(the one that's on the left of photo) the cart moves forward... pulling my hair out now!http://www.golfcartsforum.com/attach...68-1-.jpg..:-(

[Larry1950]

Major amount of corrosion. Needs some serious cleaning. Start by cleaning all the connections, but disconnect the batteries first. May need to replace the micro switches. You near saltwater?

[wthompson]

the switch with the black and white wires is for half speed reverse(black has resistor). the attached wiring diagram is for a 92 but is the same. check the f&r switch wiring to motor and controller and check all connections. could be bad connection in f&r rotor and rotor contacts. Also could be a problem with the wiper switch/speed control.

[easyrider1078]

Ok thank you! I will clean up the corrosion and then check the f&r switch wiring to motor and controller and check all connections. then check f&r rotor and rotor contacts. then I will check the wiper switch/speed control and let you all know what works...Thank you!

[easyrider1078]

can anyone tell me which post the white wire attaches to? Like a dummy I disassembled the old one and didn't photograph which ones the black and white wires came from I believe I have the black wire on the right post...right?

[wthompson]

i used your picture... what i have in the manual.

[easyrider1078]

Ok! Thank you wthompson!