V-glide wiring problem

[cozlarry]

My 94' Club Car DS with V-glide has been suffering an intermittent problem of full power lurching in reverse and a total loss of any forward power.
I have been going through all the possibles and today I removed the V-glide and found a loose white wire.
I have attached a photo of the V-glide and the loose wire in hopes that someone can tell me where it should be wired to.
Thanks to all that can help.

-Larry

[golfcartg]

Here is the color coded wiring diagram for the V-glide

It sounds like you've made some headway in diagnosing the issue. The loose white wire you found is definitely a good lead to follow, but let's delve a bit deeper into the components involved. When it comes to V-glide systems, resistors play a critical role in regulating power flow. The good news is that resistors aren't polarized, meaning they'll work in either orientation. However, they can still be the source of intermittent power problems. Check each resistor carefully, as any damage or wear could be causing the issues you've been experiencing. In my experience, I've found that repairing components like pads, arms, microswitches, or even resistors themselves can often resolve these types of issues. Thankfully, the V-glide system is relatively simple in design and operation once you get a closer look at it.

If you're in need of replacement resistors, you may have to look online, as brick-and-mortar stores like Radio Shack are becoming increasingly rare. Online suppliers like Mouser or McMaster-Carr are good options for sourcing replacement parts. Keep in mind that sometimes the culprit resistor may not be immediately obvious, especially if it's almost unnoticeable or hidden from plain view. Trust your ohm readings and methodically check each component until you find the one causing the trouble.

In the case of a faulty resistor, its position in the series can have a significant impact on the system's operation. When one resistor in the series circuit breaks, it interrupts the flow of resistance, affecting the performance of the entire system. This can result in issues like the one you described or even sluggish movement. Replacing components like resistors, pads, or arms shouldn't pose a major challenge. Just keep troubleshooting methodically. If you have any specific questions just ask!